Navigation Menu

How to take measurements

MOGdesign | Sliding door wardrobe | POLEinterior© | Installation | How to take measurements

MOGdesign sliding doors is made-to-measure and it is important to be careful doing the measuring.

When ordering with us, we will require measurements in millimetres(mm), if you work with inches (") you can use our converter tool to figure.

feet

inch

Note: 1 Inch = 2.54 cm, 1 Feet = 30.48 cm, 1 Feet = 12 Inch

Tools Required:
  - Tape measure
  - Level
  - Ladder (Optional)

Step 1 - Taking the measurements

it's required to measure in three different places for
width & height.

Check the depth available. If the sliding door system is combined with inteiror system Wardrobe interior a minimum depth of 610 mm is requires.
We recommended depth of 680 mm if space is available

1st: Take height from left side, middle, right side. Use the lowest measurement Round measurement to nearest 5 mm (i.e. 2495 mm)	Left	Middle	Right

2nd: Take width from floor, middle and ceiling. Use the widest measurement Round measurement to nearest 5 mm (i.e. 2495 mm)	Floor	Middle	Ceiling

Step 2 - Check the Level

Because MOGdesign sliding doors moved very lightly you will need to check the level of the floor. If your floor is out of level more than 12mm (1/2"), you will properly need to correct the floor level. This is best done with a liner under the floor track. If correction is not made, doors may move by themselves when they are not in closed position. Liners are 18mm thick, if the liner is placed on top of the existing floor, remember to subtract 18 mm from the height measurement. If the liner is cut into a carpet, no subtraction should be made. Best material to use as liner is MDF strip 80 mm wide.

Check also the level of side walls, if your side walls is more than 20 mm out of level, side infills could be needed - in this case please call us for advice.